have hurco autobend 5c not cycling at bottom of stroke. bottoms out instead

The HURCO Store > General Category > Technical Support AutoBend > have hurco autobend 5c not cycling at bottom of stroke. bottoms out instead

Pages: [1]

« previous next »

Author

Topic: have hurco autobend 5c not cycling at bottom of stroke. bottoms out instead (Read 1429 times)

varmitman

Newbie

Posts: 2

have hurco autobend 5c not cycling at bottom of stroke. bottoms out instead

« on: July 24, 2009, 08:12:20 AM »

after i calibrate instead of stoping to bend a 90 degree it bottoms out like its not calibrated.


	Logged

buddy

Administrator
Full Member

Posts: 240

Re: have hurco autobend 5c not cycling at bottom of stroke. bottoms out instead

« Reply #1 on: July 24, 2009, 01:18:19 PM »

Are you getting completely thru the calibration where it displays 180???

Thx
Buddy


	Logged

varmitman

Newbie

Posts: 2

Re: have hurco autobend 5c not cycling at bottom of stroke. bottoms out instead

« Reply #2 on: July 27, 2009, 08:30:36 AM »

i calibrate and set degree at 90 or any degree and machine bottoms out.its not catching the degree's that are put in computer. so i'm running machine on manuel micrometers.


	Logged

buddy

Administrator
Full Member

Posts: 240

Re: have hurco autobend 5c not cycling at bottom of stroke. bottoms out instead

« Reply #3 on: July 27, 2009, 03:28:10 PM »

If you get thru the calibration without any error then you may have a bad scale/encoder. You will need a scope to check this.

Buddy


	Logged

Pages: [1]

« previous next »